Yamaha Tricity MW125 Owner's Manual page 50

PERIODIC MAINTENANCE AND ADJUSTMENT
3
4
5
6
1. Engine oil drain bolt A
2. Gasket
3. Oil strainer
4. Compression spring
6
5. O-ring
6. Engine oil drain bolt B
4. Clean the engine oil strainer with
solvent, and then check it for
damage and replace it if neces-
sary.
5. Check the O-ring for damage and
replace it if necessary.
6. Install the engine oil strainer, com-
pression spring, O-ring and en-
gine oil drain bolt B.
TIP
Make sure that the O-ring is properly
seated.
7. Install engine oil drain bolt A, and
then tighten both drain bolts to
their specified torques.
Tightening torque:
Engine oil drain bolt A:
2 1
22 Nm (2.2 m·kgf, 16 ft·lbf)
Engine oil drain bolt B:
20 Nm (2.0 m·kgf, 14 ft·lbf)
8. Refill with the specified amount of
the recommended engine oil, and
then install and tighten the oil filler
cap.
Recommended engine oil:
See page 8-1.
Oil quantity:
0.80 L (0.85 US qt, 0.70 Imp.qt)
TIP
Be sure to wipe off spilled oil on any
parts after the engine and exhaust sys-
tem have cooled down.
NOTICE
 In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives. Do
 Make sure that no foreign mate-
9. Start the engine, and then let it idle
10. Turn the engine off, and then
11. Reset the oil change tripmeter and
ECA11621
6-11
not use oils with a diesel speci-
fication of "CD" or oils of a high-
er quality than specified. In
addition, do not use oils labeled
"ENERGY CONSERVING II" or
higher.
rial enters the crankcase.
for several minutes while checking
it for oil leakage. If oil is leaking,
immediately turn the engine off
and check for the cause.
check the oil level and correct it if
necessary.
oil change indicator
CHANGE". (See page 3-6 for reset
procedures.)
"OIL