My Clié Handheld Does Not Work Properly; I Cannot Turn On My Clié Handheld; The Screen Is Not Displayed Even Though The Power Led Is - Sony CLIE PEG-UX40 Frequently Asked Questions Manual

Troubleshooting
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
My CLIÉ handheld does not work
properly
I cannot turn on my CLIÉ handheld
B The POWER/HOLD switch of your CLIÉ handheld is in HOLD mode.
Your CLIÉ handheld does not work when the POWER/HOLD switch is
in HOLD mode. Make sure you release HOLD mode.
B The battery power of your CLIÉ handheld has run out.
Place your CLIÉ handheld on the charger cradle connected to the AC
power adapter, then allow it to be charged for a few minutes before
turning it on. If it turns on, continue charging for approximately four
hours and then perform a soft reset.
B The connector between your CLIÉ handheld and the charger cradle is dirty.
You cannot charge your CLIÉ handheld if the connector is dirty. Wipe
the connector with a soft cloth, such as a cotton pad.
B It takes a while until the screen is displayed when turning on your CLIÉ
handheld from Power Saving Mode. However, it is not a malfunction.

The screen is not displayed even though the POWER LED is

on
B It takes a while until the screen is displayed when turning on your CLIÉ
handheld from Power Saving Mode.The screen is displayed after the
POWER LED is turned on.
B The POWER/HOLD switch of your CLIÉ handheld is in HOLD mode.
The screen is not displayed when the POWER/HOLD switch is in HOLD
mode. Make sure you release HOLD mode.
B Perform a soft reset by pressing the RESET button.
b
For details, refer to "Basic operations of your CLIÉ™ handheld: Restarting your
CLIÉ™ handheld" in the supplied "Read This First (Operating Instructions)".
Continued on next page
13