Setting Up Your Clié™ Handheld; Charging Your Clié Handheld - Sony CLIE PEG-UX50 Operating Instructions Manual

01US01COV.book Page 8 Friday, June 20, 2003 6:29 AM
Setting up your CLIÉ™ handheld
Perform the following before setting up your CLIÉ handheld.
Step 1: Charging your CLIÉ handheld
Step 2: Performing the initial setup after turning on your
CLIÉ handheld for the first time
Step 1: Charging your CLIÉ handheld
Before using your CLIÉ handheld for the first time, be
sure to fully charge the battery.
1
Connect the AC power adapter to the charger cradle's AC
power adapter connector.
2
Connect the AC power adapter to a wall outlet.
3
Align and attach the front clasps of the charger cradle
with the holes on the back of your CLIÉ handheld (1),
then gently lay it down (2).
The POWER LED of your CLIÉ handheld turns on when charging starts.
Tips
• To remove your CLIÉ handheld from the charger cradle, lift up from the rear
(camera lens side).
• Clean the connectors if they get dirty.
8
Sony Personal Entertainment Organizer PEG-UX50/UX00 X-XXX-XXX-11 (1)
To a wall
outlet