Advertisement
1. Front guard
2. Spinner
3. Fan blade
4. Guard mounting nut
5. Rear guard
6. Motor housing
7. Oscillation knob
8. Speed Controls
9. Locking nut
10. Base surround
11. Screws
The moulded base surround is supplied
with 3 retaining screws (in a small bag
taped to the inside of the surround).
Remove the bag containing the screws
and position the surround on the
moulded retaining clips on the base and
snap into place. Ensure that the surround
has clipped firmly into position onto the
fan base and screw the 3 retaining screws
into the holes across the middle of the
base. Do not over-tighten these screws.
Take off guard lock nut from motor shaft.
Place the rear guard on the front of the
motor housing. Line up the lugs on the
front of the motor housing with the holes
in the rear guard. Screw on guard lock nut
tightly to attach rear guard.
Components
3
2
1
Assembly
Place the fan blade on the motor shaft
and secure it by tightening the fan blade
nut.
Fit the front guard (1) onto the rear guard
and close the clips, then secure the grill
with the small screw provided.
6
5
4
8
9
10
11
7
Advertisement
