Table of Contents
Advertisement
Publication no. 201102
4.6 Replacing the Operator display
• Power down the Camera before starting this work.
• Open the top of the camera.
Operator
Display
C (x4)
• Locate the operator display.
• Disconnect the data cable 'A' and the back ground light cable 'B'.
!
CAUTION
The background light is supplied with high voltage. This voltage is gene-
rated by a inverter located on the main board. Make sure the unit is po-
wered down before disconnecting the background light.
• The display is hold by the four screws 'C'. Remove these screws and take out the dis-
play.
• Insert the new display and tighten the screws.
• Connect the operator display cable 'A' and the background light cable 'B'.
• Close the cover and power up the unit.
• Verify function.
September 2003
A
B
24
NIC2-2 · Network ID Camera
Triacon AB Sweden
Advertisement
Table of Contents
