Installing Probe Water Sensors; Installing Rope Water Sensors - Multitech RBS3010EU22BN00 User Manual

QUICK START

Installing Probe Water Sensors

Install the water sensor so the probe reaches an area where water leaks may occur, such as water heaters,
standing tanks, windows/doors, toilets, septic systems, condenser and refrigeration systems, floor drains, or water
control valves. The probe may be placed inside containers to detect water.
Note: The probe is designed for water detection. It is not rated for use with harsh chemicals, solvents, oils,
fuels, strong acids, or other caustic liquids.
1. Use the small adhesive pad attached to the probe to install it so the metal pins are flat on the floor. This
allows the pins to make contact with a puddle from a nearby leak and send an alert. Place the probe
where water from a leak would likely accumulate.
2. Use the included large adhesive pad to secure the case to the wall.
For increased security (optional), fasten the case to the wall using the included tamper screw as shown.
The tab will break away and send a tamper alert if the case is forcibly removed from the wall.
3. Assemble the case.
4. Coil any excess wire.
5. Secure the probe to the floor or wall using the small adhesive pad or with an appropriately sized screw in
any of the probe's wall or floor mounting holes.

Installing Rope Water Sensors

Rope water sensors detect leaks along the length of the rope, it can be wrapped around a fixture or spread across
a room, dropped ceiling, or anywhere you need leak detection. Install the sensor so the rope reaches the area you
want to monitor for water leaks.
8 Radio Bridge LoRaWAN
If needed for better positioning, run the wire along pipes or around obstacles.
For best radio performance, avoid placing the sensor in another enclosure or in an area
crowded with other equipment.
®
Wireless Sensor Water Detect Sensor with Temperature and Humidity User Guide