Philips Home power SRP4319S/27 User Manual page 8

Programming Your Remote
1.
2. Press and hold down the SETUP
3. Press and release the device
4. With the remote pointed at the
5. Manually turn the device back on.
6. With the remote pointed at the
Manually turn on the device you
wish to control.
NOTE: The Auto Code Search
process cannot be used for devices
without power ON/OFF capability.
Use the Direct Code Entry method in
these cases.
button on the remote until the red
light on the remote control turns
on. Release the SETUP button.
The red light will remain on.
NOTE: The red light will either be a
small light at the top of the remote
or the power ON/OFF button.
button on the remote for the type
of device you wish to control, (e.g.,
TV, S-BAR, B-RAY, STRM). The red
light will blink once and remain on.
device, press and release the
POWER button on the remote.
The remote will send 10 different
codes to the device. The red light
will blink once for each code and
remain on after sending the 10
codes.
Did the device turn off?
• If YES, go to Step 5.
• If NO, repeat Step 4 to test the
next 10 codes.
device, press and release the
VOL
button. The remote will re-
send the first code of the 10 codes
from Step 4. The red light will blink
once and remain on.
Did the device turn off?
• If YES, you have found a code
for the device. Press and
release the same device button
you pressed in Step 3. This will
8