Table of Contents
Advertisement
Malfunction
The machine fills then empties
immediately:
The machine does not empty and/or
does not spin:
There is water on the floor:
Unsatisfactory washing results:
20
Possible Cause / Solution
The end of the drain hose is too low.
Refer to relevant paragraph in «water drainage»
●
section.
The drain hose is squashed or kinked. (Red pilot
light flashes)
Check the drain hose connection.
●
The drain pump is clogged. (Red pilot light flashes)
Clean the drain pump.
●
The laundry is not evenly distributed in the drum.
Redistribute the laundry.
●
The RINSE HOLD option or SOAK programme have
been selected.
Select Drain or Spin programme.
●
Too much detergent or unsuitable detergent (creates
too much foam) has been used.
Reduce the detergent quantity or use another one.
●
Check whether there are any leaks from one of the
inlet hose fittings. It is not always easy to see this as
the water runs down the hose; check to see if it is
damp.
Check the water inlet hose connection.
●
The inlet hose is damaged.
Change it with a new one.
●
The cap on the emergency emptying hose has not
been replaced after cleaning the pump.
Put the cap back on the emergency emptying hose
●
and place the latter back in its seat.
Too little detergent or unsuitable detergent has been
used.
Increase the detergent quantity or use another one.
●
Stubborn stains have not been treated prior to
washing.
Use commercial products to treat the stubborn
●
stains.
The correct temperature was not selected.
Check if you have selected the correct temperature.
●
Excessive laundry load.
Introduce into the drum less laundry.
●
Advertisement
Table of Contents
