Ember Placement - Hargrove ETCC30N1G Installation And Operation Manual

WARNING: IMPROPER INSTALLATION OF THE EMBER MATERIAL MAY
LEAD TO CARBON MONOXIDE POISONING.
EMBER PIECE
Fig. 1
1. Tear the Ember Material into individual pieces (Fig 1).
2. Slightly stretch each Ember piece so it can be placed on the front burner ports and be
supported by the front grate and burner (Fig. 1 & 2).
3. Place the pieces of Ember Material evenly across the front burner so as many front burner ports
can be covered as possible. (Fig 3 & 4)
DO NOT PRESS THE EMBER MATERIAL INTO THE BURNER PORTS.
4. You may place some ember material on the tube that connects the front and back burner. Do
not press the ember material into the ports as it may obstruct the ignition of the front burner.
DO NOT PLACE ANY EMBER MATERIAL ON THE BACK BURNER (Fig. 3)
Fig. 3
DO NOT PLACE ANY EMBER
MATERIAL ON BACK
BURNER!
WARNING: DO NOT PUT ANY ADDITIONAL EMBER MATERIAL ON THE
BURNER SYSTEM. USE ONLY WHAT WAS PROVIDED WITH THE SET.
PLACING ADDITIONAL EMBER MATERIAL ON THE SET MAY CAUSE IMPROPER
COMBUSTION AND WILL VOID THE MANUFACTURER'S WARRANTY.

EMBER PLACEMENT

Actual
Size
Fig. 2
Front Grate
Fig. 4
Front Burner with Embers Properly Installed
Front Burner/Burner Ports
PLACE THE PLATINUM BRIGHT
EMBERS IN INDIVIDUAL PIECES
ON TOP OF THE EMBER
MATERIAL.
13