Mitsubishi Electric CITY MULTI PAC-YT53CRAU Installation Manual page 20

9 Function Selection for CITY MULTI
Make this setting only when the function settings need to be changed on CITY MULTI.
(This setting cannot be made with M-Series and P-Series Control System. To make settings
for M-Series and P-Series, refer to section
Set the functions of each indoor unit from the remote controller, as required.
Refer to the Indoor unit Installation Manual for factory settings, mode No., and the setting No. of the
indoor units.
NOTE: Be sure to write down any settings that you change performing the following steps.
■ Setting the indoor unit Setting Value
1 Press the [ON/OFF] button to stop the operation of the air conditioner.
2 Press and hold down the [MODE] and the [
or longer to check the current settings.
3 When the response has been received from the indoor unit, the current settings appear. If
there is no response, nothing appears.
2 sec.
[MODE]
+
[FAN]
Air conditioner
stops.
4Press the [TEMP.
settings to be made. (0 to 50)
5Press the [MODE] button, then press the [TEMP.
Function Setting No. to be set. (000 to 255)
6Press the [MODE] button, then press the [TEMP.
Function Setting Value. to be set (00 to 15)
7Press the [ON/OFF] button to set the settings.
8
Waiting for response
Response is received.
Response has been received.
] and the [TEMP. ] buttons to set the address of the indoor unit whose
– 20 –
Function Selection for M-Series and P-Series
FAN] buttons at the same time for two seconds
No
response
No response
Function Setting Value
Function Setting No.
Indoor unit address
] and the [TEMP.
] and the [TEMP.
.)
Procedure A
] buttons to set the
] buttons to set the