GE PFD87 Owner's Manual & Installation Instructions page 35

STACKING THE WASHER AND DRYER
TOOLS YOU WILL NEED
Phillips screwdriver
Open-ended wrench
CONTENTS
Bracket 32
(2)
Spacer (2)
REMOVE THE DRYER LEVELING
1
LEGS
A. Carefully lay the dryer on its back or side. Use the
packing material so you don't scratch the finish on
the dryer.
B. Use an open-end wrench or pliers to remove the
dryer leveling legs. NOTE: Retain the leveling legs
for future use.
Back out and
remove all 4
leveling legs
49-3000386 Rev 0
Installation Instructions
Pliers
Gloves
Level
Bracket 34
(2)
#8 1/2" (12.7 mm)
Screws (16)
INSTALL SPACERS TO THE
2
DRYER BOTTOM
Locate a spacer on the bottom side with its holes over
the leveling leg holes. Attach spacer using 2 screws.
Attach the second spacer on the other bottom side
using 2 screws. NOTE: The arrows on the spacers
should point to the outside.
Make sure the arrows on the spacer point to the outside.
Attach spacer using 2 screws
Front
Attach spacer using 2 screws
Make sure the arrows on the spacer point to the outside.
(Optional Kit GFA28KITN)
Back
35