Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Norma REVO IPA-80
Summary of Contents for Norma REVO IPA-80
- Page 1 REVO IPA-80 Manual www.normaudio.com - info@normaudio.com...
- Page 2 Safety manual REVO IPA-80...
- Page 3 Documentation Conventions This document contains general safety and operation instructions for your Norma product. It is important to read this document before attempting to use this device. Please pay particular attention to safety instructions. The information that the manual contains is subject to change without notice.
-
Page 4: Unpacking
RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: • Grab the underside of the NORMA unit and lift it straight TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE out of the packing box; COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. -
Page 5: Before Use
We are not responsible for injuries or damages due to a wrong positioning. Do not put III.I General NORMA devices on high places, to avoid injury from tip- over or falling. This product cannot be mounted to a wall III.I.I • Read these instructions or ceiling. - Page 6 The AC fuse inside the unit is not user-serviceable. If you rating of 13 amps and that it is approved by ASTA or BSI cannot turn on the unit, contact your NORMA dealer. to BS1362. Check for the ASTA mark or the BSI mark on the body of the fuse.
- Page 7 Unauthorized substitutions may result in fire, electric shock, or other hazards. Use only accessories and optional boards specified by the manufacturer. Clone or non-original accessories may result in fire, electric shock or other hazards. III • Before use REVO IPA-80 / Safety manual...
-
Page 8: Operating
Turn off restaurant or use in a car or ship) and which requires all systems power before connecting the NORMA unit to repair will be charged for even during the warranty any other component. For additional security, remove period. -
Page 9: Recycling & Waste
When discarding the unit, comply want to discard it: with local rules or regulations. Please contact your NORMA dealer who will inform you Batteries should never be thrown away or incinerated about the take-back and recycling. Small products (and... - Page 10 User manual REVO IPA-80...
- Page 11 CONGRATULATIONS First of all, we would like to thank you for the trust you have placed in NORMA. The product you purchased is the result of a long research and development process in which we have put our technical experience, and our passion for music. This products will offer you the best that technology has expressed for high quality sound reproduction.
-
Page 12: Controls And Connections
In STANDBY the indicator is illuminated at low intensity. In case of intervention of the protection circuits the indicator flashes at low intensity. When the MUTE function is active the indicator flashes at high intensity. REVO IPA-80 / User manual 1 • Controls and connections... - Page 13 Short circuit and shock hazard. I / L • IN 1: RCA connection sockets Input socket for signal IN 1 [phono] channel right / left. 1 • Controls and connections REVO IPA-80 / User manual...
- Page 14 • Reduce the connection cables length; 1.3.1 • Technical notes about inputs • Change signal cables and power cables position; The REVO IPA-80 amplifier has 6 inputs, 2 of them are configurable by the user. • Increase the distance between units, or arrange them The input IN 4, as well as being a normal input line, can in a different way;...
-
Page 15: Start To Use
Inside the amplifier REVO IPA-80 there are some input signal. Pay attention to the input level, To avoid sophisticated protection circuits that control the sending too much power to the speaker. -
Page 16: Maintenance
3.2 Repairs Caution: For any issues please refer to the safety manual. NORMA To prevent damage, each connection must be carried products are the result of precision engineering with out when the appliance is switched off and unplugged... -
Page 18: Aux Overview
Aux overview REVO IPA-80 RISK OF ELECTRIC SHOCK DO NOT OPEN WARNING: As indicated in the safety manual, we remind you that the actions described below must be performed only by highly qualified personnel. There are very high and dangerous electrical voltages inside the device. - Page 19 F 1,6 A Fast Fuse Tab. Aux 1 Fuse specifications Fig. Aux 1 DC filter, jumper and fuse position FILT Fig. Aux 2 DC filter setting Fig. Aux 3 Jumper position 4 • Aux overview REVO IPA-80 / Aux overview...
- Page 20 It must be carried out by centers. Wea re not responsible for any injury or qualified personnel in compliance with all safety damage due to a wrong operation. REVO IPA-80 / Aux overview 4 • Aux overview...
- Page 22 PH1 phono Optional...
-
Page 23: Phono Stage
5.1.2 • Gain Settings are obtained via micro-switches 5 - 8 on the The NORMA PH1 phono allows for a series of fine settings PCBs SW1R and SW1L, respectively for the right and left and options, in order to achieve the best connection with channels, as shown in the pictures on page two. - Page 24 USB board Optional...
-
Page 25: Usb Connection
The user is responsible for having the necessary knowledge to properly use this type of devices. NORMA can’t be held responsible to eventual problems, malfunctioning or damages caused by a improper use of informatic resources and their interfacing. -
Page 26: Specifications
Electrolytic, Total 37500 μF; Dimensions (HxWxD) [mm] 90x440x360; Carton Box Size (HxWxD) [mm] 220x550x450; Weight [Kg] 15Kg. In order to improve its products, NORMA reserves the right to change technical specifications and appearance without notice. REVO IPA-80 / Specifications 7 • Specifications... - Page 28 Remote controls REVO IPA-80...
-
Page 29: Aluminium Remote Rc-43
Note: An abnormal functioning of your NORMA device could be due to an IR interference, coming from Plasma TVs, PC monitors or different remote controls. -
Page 30: Remote Controls Description
Moves backwards in MENU (direct Input selection on REVO IPA-80 / REVO IPA-140) VOL. UP FAST FAST volume UP (direct volume UP control on REVO IPA-80 / REVO IPA-140 / REVO SC-2 / HS-IPA1) VOL. DOWN FAST FAST volume DOWN (direct volume DOWN control on REVO IPA-80 / REVO IPA-140 / REVO SC-2 / HS-IPA1) VOL. - Page 31 Command Symbol Description MODE Sets remote control on AMP MODE (for REVO IPA-80 / REVO IPA-140 / REVO SC-2 / HS-IPA1) MODE Sets remote control on DIG MODE (for REVO-DAC1 / HS-DA1) POWER ON-OFF Turns the unit ON and OFF Enters the menu setup sonfiguration,...
- Page 32 9.3 IR-43 system remote control: commands list, general description If you have 2 or more NORMA products and you want to control them with a single remote control, you can request IR-43 remote control from NORMA. Command Symbol Description MODE...
- Page 34 Warranty REVO IPA-80...
-
Page 35: Warranty Conditions
Any unit which has been altered or on which the serial number 10.2 Warranty content has been defaced, modified or removed; • NORMA will, at its option, repair or replace the product Normal wear, battery or battery replacement and any periodic covered by this warranty if it becomes defective, maintenance;... - Page 36 10.6 Responsibility limits • The lasting of the warranty period cannot be interrupted • NORMA does not guarantee that the use of any its for any reason. The non-use of this product does not product is continuous or free from any error or free from interrupt or extend the warranty period.
-
Page 38: Table Of Contents
Table of contents REVO IPA-80 Safety manual • Introduction II • Unpacking III • Before use IV • Operating V • Recycling & waste User manual 1 • Controls and connections 2 • Start to use 3 • Maintenance Aux overview 4 •... - Page 39 www.normaudio.com - info@normaudio.com - Tel. +39 (0)372 493113 Via Persico, 26 - Loc. Bettenesco - 26043, Persico Dosimo (CR) - Italy...