Replacing The Lithium Battery - Sony VAIO PCV-J150 Reference Manual

Replacing the Lithium Battery

You may need to replace the lithium battery if your computer consistently
loses the date or time settings after turning it off. The lithium battery has
a typical life of three years, after which the battery may be too weak to
power the CMOS memory.
!
When you remove the lithium battery, all values stored in the CMOS
memory (BIOS setup values and Plug and Play values) may be lost.
Although the computer can hold the charge for a short time while replacing
the battery, it is safer to assume that the settings will be lost. When the
values are lost, the BIOS values revert to their factory-default settings (see
"Accessing the BIOS Setup Utility"
Do not handle damaged or leaking batteries.
The lithium battery may explode if mistreated. Do not disassemble it or
dispose of it in fire.
1
Reboot your computer by selecting Shut Down... from the Start
menu, and then selecting Restart the computer.
2
If the error message "Error: Check date and time settings"appears
during the reboot sequence, press F2 during the reboot process to
access the BIOS Setup Utility. Otherwise it is not necessary to replace
the battery at this time, and you can skip all remaining steps.
3
Compare all the BIOS options to their default settings (see
Setup Options"
are different from their default values. You will refer to this list when
you restore the BIOS settings later.
4
Select Exit Discarding Changes from the main menu using the right
arrow key.
5
Press Enter, type Y when prompted to discard changes, then press
Enter to exit the BIOS Setup Utility.
6
Turn off the computer and unplug the power cord.
7
Remove the side panel (see
Removing, Installing, and Replacing Components
on page 67). Make a list of all the BIOS options that
"Removing the Side Panel"
on page 16).
29
"CMOS
on page 22).