Maximum Tightening Torques - Jäger Z62-M445.01 S5 Manual

Short clamping bore
Continuous clamping bore
Item no. 10004021, Revision 02
Proceed as follows to change the tool:
Ü Use the hook wrench to unfasten the clamping nut and the collet.
Ä Make use of the hook wrench from the scope of delivery of the HF spindle.
Ü Remove the tool.
Ü
Screw the clamping nut out.
Ü
Remove the collet from the taper of the mount.
Note: Ensure functionality.
All contamination damages the collet, clamping nut, tool mount, etc. As a re-
sult, the function of the HF spindle is no longer guaranteed.
u Clean the collet.
u Clean the clamping nut.
u Clean the thread of the shaft.
u Clean the inner taper of the shaft.
Ü
Lightly grease the thread of the clamping nut.
Ü
Push the collet into the taper of the mount.
Ü
Insert the tool.
Ü Make sure that the shank of the clamped tool does not press on the inner
stop of the tool mount once the clamping nut has been tightened.
Ü To prevent the clamping nut from loosening, tighten it again after a short
period of operation and when the shaft is at a standstill.
10.2.1

Maximum tightening torques

Excessive tightening torques (M
nut, and collet mount of the shaft.
Keep to the following values.
Ü
Short clamping bore
Ä Clamping diameter: 1,0 - 4,5 mm
Ä Ma max.: 18 Nm
Ü Continuous clamping bore
Ä
Clamping diameter: 5,0 - 10,0 mm
Ä Ma max.: 28 Nm
Tool change
) can damage or destroy the collet, clamping
A
27 ( 36 )