Speed Sensor (Digital Differential Magneto Resistor); Air-Borne Noise Emissions - Jäger Z62-M445.01 S5 Manual

DFP = digital differential magneto
S = signal
Item no. 10004021, Revision 02
6.5

Speed sensor (digital differential magneto resistor)

Trouble-free evaluation requires good wiring.
Ü Use twisted and shielded cables.
Ü Connect the HF spindle based on the connection example shown below.
Note: Resistor (Rx).
If the resistor (Rx*) is already integrated in the evaluation unit (FC):
u Only connect signal and ground.
Supply voltage (U)
resistor
*Unnecessary if a resistor is integrated in the evaluation unit (frequency converter, etc.).
**Values may differ by ±20% depending on the measuring method.
6.6

Air-borne noise emissions

CAUTION: Noise has an impact on health.
u Only operate the HF spindle if you are wearing hearing protection.
Technical Specifications
+ 8 V
+ 8 V
+ 12 V
+ 12 V
+ 15 V
+ 15 V
+ 24 V
+ 24 V
Rx (*) Signal (**)
220 Ω 1000 mV
450 Ω 2000 mV
220 Ω 1000 mV
680 Ω 3000 mV
220 Ω 1000 mV
680 Ω 3000 mV
220 Ω 1000 mV
680 Ω 3000 mV
19 ( 36 )