Table of Contents
Advertisement
Example of design: Inserting the
Sample illustration:
Direction of rotation indication
26 ( 36 )
Tool change
10
Tool change
CAUTION: Danger of being drawn in by rotating shaft.
If the shaft is still rotating, fingers and hands may be drawn in and crushed.
u
Only change the tool if the shaft is at a standstill.
Note: Ensure functionality.
u
Never operate the HF spindle without a clamped tool shank.
If no tool shank is clamped:
q
The clamping system is damaged by the centrifugal forces.
q
The clamping system is shifted.
q
The balance of the HF spindle is affected.
shank
q
The bearing is damaged.
10.1
Clockwise
The HF spindle clamping system is designed for clockwise rotation.
Ü
Only use tools with the correct direction of rotation for the HF spindle.
Ü
Only use tool mounts with the correct HF spindle direction of rotation.
Ü
Set the direction of rotation of the HF spindle on the FC in accordance with
the arrow display on the HF spindle.
10.2
Manual tool change
End face
1
2
Clamping nut
Collet (optional accessory)
3
Item no. 10004021, Revision 02
Advertisement
Table of Contents
