Table of Contents
Advertisement
Quick Links
Installation, Operation and Maintenance Manual
IMPORTANT
Please take a moment to review this manual. Before performing any maintenance on the valve be sure the pipeline has been depressurized. The
improper installation or use of this product may result in personal injury, product failure, or reduced product life. Tideflex
resulting from the improper use or installation of this product. If you have any questions or problems, please call the customer service department
at (412) 279-0044. We appreciate your comments. Thank you for choosing Tideflex
Series 37 Inline Check Valve
The revolutionary design of the Series 37 Inline Check Valve
provides absolute backflow protection. This unique "duck
bill" design eliminates costly backflow from oceans, rivers or
storm water and is the ideal valve for effluent diffuser systems.
The Series 37 Check Valve is available in a wide variety
of elastomers and is designed to meet your exact flow
specifications.
Series 37 Valves are constructed with 125# ANSI flanges,
which have the same drilling pattern as ANSI 150# for ease
of installation.
• Simple design
• Cost effective
• No cavities or dead spots
to bind valve operation
• Low maintenance
.
®
IOM RV09.02-4
February 2023
can accept NO liability
®
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Red Valve TIdeFlex 37 Series
Summary of Contents for Red Valve TIdeFlex 37 Series
- Page 1 IOM RV09.02-4 February 2023 Series 37 Inline Check Valve Installation, Operation and Maintenance Manual The revolutionary design of the Series 37 Inline Check Valve provides absolute backflow protection. This unique “duck bill” design eliminates costly backflow from oceans, rivers or storm water and is the ideal valve for effluent diffuser systems.
- Page 2 INSTALLATION 1. INSPECTION OF VALVE: 3. INSTALLING FLANGE BOLTS: Check flange faces of pipe for rough/damaged areas. Pipeline Tighten all bolts uniformly to distribute pressure evenly around the flanges must be flat, properly spaced, and parallel to achieve sleeve flange.(For complete information on bolting dimensions proper seal.
- Page 3 MAINTENANCE TROUBLESHOOTING SYMPTOM: 1. INSPECTION: LEAKAGE AT FLANGE Valves should occasionally be inspected for damage and wear. • Retighten all flange bolts uniformly, as explained on the The inspection period should be determined by the severity of back cover of this IOM. the service and environment.
- Page 4 Red Valve • 750 Holiday Drive, Suite 400, Pittsburgh, PA 15220 • 412-279-0044 • support@redvalve.com • RedValve.com © 2023 Red Valve Company...
- Page 5 Limited Warranty Red Valve Company (“Seller”) manufactured products, auxiliaries and parts thereof that we manufacture for a period of twenty-four (24) months from date of shipment from Seller’s factory, are warranted to the original purchaser only against defective workmanship and material, but only if properly stored, installed, operated, and serviced in accordance with Seller’s recommendations and instructions.
Need help?
Do you have a question about the TIdeFlex 37 Series and is the answer not in the manual?
Questions and answers