PoE Switch
EN-PEX4GBC
Tablet
Data & Power
Input
Type-C Power
PoE Data
Output
& Power
Output
PD
2-1
Device Connection
Caution:
1.Please read the instructions carefully and follow the standard operating
procedures before using.
2.Please place it in a well-ventilated and dry area, and it is for indoor use
only.
3. Connect a CAT5/5e/6 cable with the RJ45 connector into the RJ45
socket labeled PoE In.The total Ethernet cable length can not exceed 100
meters.
!
4. Connect a CAT5/5e/6 cable with the RJ45 connector into the RJ45
socket labeled PoE 1,PoE2, PoE3 and PoE4. On the other end of the
CAT5e/6 cable, connect to your PoE powered Device (PD, such as IP
Cameras etc). The total Ethernet cable length can not exceed 100 meters.
5.Daisy-chain 2 units reaching 300m from end to end or by star
topology can power up 7 PDs.
6. The device must be placed on a stable surface, preferably affixed and
mounted permanently. Do not leave it "dangling" and use plugged-in
cables in tension as support. Drops, falls, and impacts experienced by the
injector can compromise the internal components & cause premature
failure.
7. Do not place heavy objects on top of this injector. Allow at least 5cm of
clearance on all sides of the device for heat ventilation / natural
convection.
Installation Preparation 05