Page 2
Declaration This document belongs to PROCET company. It is not allowed to reproduce and modify without the original author's permission. It is PROCET's policy to improve its products as new technology, components, software, and firmware at any time. PROCET, therefore, reserves the right to change specifications without prior notice.
Page 7
Indicator Display: Items Status Description Solid Light PD is powered(Default/Normal) PoE Load Indicator No connection to PD Light Off Green Data available(Normal) Data Flashing Light Indicator Light Off No Data transmission Yellow Light Off PoE Switch is powered off/defective. 1.3 Specification...
Page 8
2. Installation Preparation 2.1 Package Contents Open the box of the EN-PEX4GBC and carefully unpack it, the box should contain the following items: EN-PEX4GBC Operation Manual 2.2 Inspection 2.2.1 Connect the device to an 802.3bt standard or passive 90W PSE or PoE switch and check the PoE Load Indicator is solid green to ensure proper function before installation. 2.2.2 Connect the PoE port to the PoE powered device(PD). Such as the IP Cameras or Wireless APs. As showed in Figure 2-1;...
Page 9
PoE Switch EN-PEX4GBC Tablet Data & Power Input Type-C Power PoE Data Output & Power Output PD 2-1 Device Connection Caution: 1.Please read the instructions carefully and follow the standard operating procedures before using. 2.Please place it in a well-ventilated and dry area, and it is for indoor use only. 3. Connect a CAT5/5e/6 cable with the RJ45 connector into the RJ45 socket labeled PoE In.The total Ethernet cable length can not exceed 100 meters.
Page 10
3. Installation 3.1 Inspection Inspect the installed equipment before putting it into operation: · Make sure the PD is compliant with our product. · Make sure the Ethernet cable connection is correct. Make sure all connections are correct, inspect all the indicators. Caution:...