Troubleshooting - Sharper Image SPIN 10 Owner's Manual

TROUBLESHOOTING

PROBLEM
The unit fails to
power on.
Unit is not pro-
ducing sufficient
amount of air.
Remote Control is
not working.
GFCI has tripped.
POSSIBLE CAUSE AND SOLUTION
Unit is not plugged in.
Unit is damaged or in need of repair. Cease usage and unplug.
Contact Consumer Service for assistance.
Ensure unit is set to highest setting for maximum air circulation.
Allow the unit to fully circulate the air throughout the room, this
may take several minutes.
Ensure all air inlets and outlet grille are unobstructed.
The battery is dead. Replace with 2 new AAA batteries. Refer to
REMOTE CONTROL - Battery Replacement for instructions.
Under certain conditions, it is possible for a reset GFCI (Ground
Fault Circuit Interrupter) outlet to trip when the user is changing
speeds on a fan. In this event, change to an outlet that is not
connected to a GFCI device. It could also indicate a weak or
defective GFCI outlet. Contact a qualified electrician to check
the GFCI outlet.
English 15