Sharper Image SBM1-SI, SBS1-SI, SBV1-SI Manual
![]()
HOW TO USE
Connect to power in two ways:
![]()
Insert the USB plug of DC cord into the USB connector of your computer.
OR
![]()
Insert the USB plug of DC cord into the AC adaptor provided and then plug AC adaptor into a power outlet.
POWER ON / OFF
- Touch (
) to power unit on. - There are two speeds: HIGH and LOW.
Touch (
) to select desired speed - Touch (
) to cycle through speeds and turn unit off.
CLEANING & STORAGE
Your fan will need regular cleaning. The fan has no user serviceable parts inside and cannot be opened for cleaning. Never clean the product in any manner other than instructed in this owner's guide.
- Power off and unplug the unit prior to cleaning.
- Dust or wipe the fan with a damp cloth.
- Use the brush attachment on your household vacuum cleaner to vacuum any accumulated dust.
Note: The motor is permanently lubricated and requires no oiling.
During the off-season or after extended periods of non-use, you may choose to store your fan. To ensure long life of the product, it is recommended to store your fan by following these instructions:
- Unplug AC adapter and bundle cord loosely.
- Cover, or place back in retail carton if available. This prevents fan from accumulating dust over time.
- Store fan in cool and dry location.
TROUBLESHOOTING
PROBLEM | POSSIBLE CAUSE AND SOLUTION |
The unit fails to power on | Unit is not plugged in. Plug Power Cord into USB outlet or AC adapter. If using the AC adapter, check that it is plugged into an AC outlet. Ensure unit fan speed setting is selected. Unit is damaged or in need of repair. Cease usage and unplug. Contact Consumer Service for assistance. The outlet is worn or damaged. Try another outlet for AC adapter or contact a qualified electrician. |
Airflow is weak or slow | Unit set to a low speed setting. Adjust to a higher speed setting. Airflow is blocked. Remove obstruction. Adjust direction of airflow towards the user. |
GFCI has tripped | Under certain conditions, it is possible for a reset GFCI (Ground Fault Circuit Interrupter) outlet to trip when the user is changing speeds on a fan. In this event, change to an outlet that is not connected to a GFCI device. It could also indicate a weak or defective GFCI outlet. Contact a qualified electrician to check the GFCI outlet. |
IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
This owner's guide and any additional inserts are considered part of the product. They contain important information about safety, use and disposal. Before using the product, please familiarize yourself with all operating and safety instructions. Please keep all documents for future reference and pass these documents on, together with the product, to any future owner.
INTENDED USE: This product is intended to circulate the air in indoor living spaces on y in the United States and Canada. This product is not intended for commercial or industrial use. The manufacturer assumes no responsibility for damage or injury due to unauthorized use or product modification. Failure to follow these directions will void the product warranty.
![]()
Risk to Children and Impaired Persons
- Supervision is required during the installation, operation, cleaning and maintenance of this product by children under age 12 and anyone with reduced physical, sensory or mental capabilities. Children should be supervised to ensure that they do not play w th the appliance, its parts and packaging material.
![burn hazard]()
![]()
![burn hazard]()
INSTALLATION WARNING - To reduce risk of fire, electrical shock and injury to persons, observe the following:
Place this product away from curtains, draperies, tablecloths and other fabrics, since they may be drawn into the fan, damage the motor and/or cause a fire. - No part of this product (the appliance, power cord, plug, packaging, etc.) should be placed near furnaces, fireplaces, stoves or other high temperature heat sources. Do not use this product in a window, on an uneven or unstable surface, or near water.
- The appliance, power supply, power cord and plug cannot come into contact with water. Do not use this product on wet surfaces. Do not use this product in a bathtub or shower or position product where it may fall into a bathtub, laundry, swimming pool or other water container. Do not use this product outdoors or expose it weather or elements.
- Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Do not route cord under furniture or appliances. Arrange cord away from traffic area and where it will not be tripped over. The cord should not hang over edges of counters or be placed where it can be crimped or closed in doors. Pace appliance near an easily accessible outlet so the product can be unplugged quickly during an emergency.
![burn hazard]()
![]()
![burn hazard]()
SAFE USE WARNING - To reduce risk of fire, electrical shock and injury to persons, observe the following:
![]()
To reduce likelihood of circuit overload, fire and electric shock, do not operate with a solid state speed device, such as a dimmer control switch. - Do not operate any fan with a damaged cord or plug. Discard fan or return to an authorized service facility for examination and/or repair.
Do not operate unit if it has been dropped or is damage is apparent to any part of the unit. To avoid risk of electrical shock, do not attempt to repair or replace parts. Only original replacement parts may be used. Contact (833.800.8669) or (help@sihomecomfort.com) for further instructions about replacement and repair.
Risk of fire. Your appliance is equipped with a detachable power supply. Use only the power cord and plug provided. - Before plugging the AC adapter into an electrical outlet, be sure that all electrical information on the AC adapter rating label, including voltage, is compatible with your outlet's power supply.
- Never use the cord as a handle or otherwise yank, strain or stretch the power cord.
![burn hazard]()
![shock hazard]()
While the product is plugged in, do not insert or allow foreign objects to enter any input or output opening as this may cause risk of electric shock or fire, or damage the product. - A loose fit between wall outlet (receptacle) and plug may cause overheating and distortion of the plug. Discontinue use of the product in this outlet. Contact a qualified electrician to replace loose or worn outlets.
- Before moving, repositioning, servicing, cleaning and when not in use, use the product controls to turn off the power and then unplug. To disconnect the AC adapter from outlet, grasp and pull only the plug. Also, power off and unplug if the product will be left unattended for an extended period of time or during electrical storms.
![burn hazard]()
![]()
![burn hazard]()
SERVICING WARNING - To reduce risk of fire, electrical shock and injury to persons, observe the following:
- Clean your product regularly, only as is instructed in this manual. Prior to cleaning, turn off the power on your product and unplug. Do not use gasoline, thinners, solvents, ammonias or other chemicals for cleaning. Refer to the CLEANING instructions provided.
Do not open appliance housing while product is plugged in. To avoid risk of shock, all service and/or repairs must be done by an Authorized Service Center.
WARRANTY
For warranty or repair service: Call 833-800-8669 or email help@sihomecomfort.com to obtain a Return Authorization ("RA") form. Please have or include your Product's model number and serial number, as well as your name, address, city, state, zip code and phone number when contacting Vornado for warranty service.
After receiving the RA form, ship your Product to: Vornado Air LLC Attn: Warranty & Repair 415 East 13th Street Andover, KS 67002. For your convenience, please have your model number and serial number when contacting Vornado with service inquiries.
Vornado Air LLC, Andover, Kansas 67002 USA.
Specifications subject to change without notice.
Documents / ResourcesDownload manual
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Download Sharper Image SBM1-SI, SBS1-SI, SBV1-SI Manual
Need help?
Do you have a question about the SBM1-SI and is the answer not in the manual?
Questions and answers