Table of Contents
Advertisement
The range for the cable diameter is 0.25 inches to 8 inches. By entering the diameter of the
wire or cable, the system automatically calculates an additional length of label to allow
complete wrap of the wire/cable with additional label material left for the flag.
Note:
If using pre-defined die-cut media, the Flag Length and Cable Diameter
fields will be grayed out and not available for input.
When finished, navigate to
6.
Rotation is embedded in the template design, based on the flag design you pick. Justification is
defaulted to center, middle, and autosize is automatically turned on.
If the design chosen indicates only one text element, the printer automatically duplicates the
entered text for the other area, rotating according to the predefined layout.
In a 2-text element flag layout, you enter text in two separate areas. Use the [Alt + Next Area/
Prev Area] keys to move to the different areas. The status bar indicates which area you are in.
Figure 35 • Number of areas based on Flag configuration
and press Enter
.
Flags
Accessing a Label Type
BMP ® 51 User's Manual
95
Advertisement
Table of Contents
