Philips FC6408/01 Manual page 9

Problem
The water flow from the
water tank is reduced
The output of water is
faster and larger than
normal.
The floor dries with stripes
when I use the water tank.
FC6409: The mini turbo
brush does not function
properly.
Possible cause
The wetting strip is blocked
by excessive residue.
The microfiber mopping pad
is not placed correctly. It
covers the wetting strip and
blocks the water flow from
the wetting strip.
The water tank is empty or
nearly empty.
You use a microfiber
mopping pad that is not
supplied by Philips.
If the water tank produces an
uncontrolled and too large
amount of water, the cap of
the tank is probably not
closed properly.
The strip is not placed
properly in the bottom of the
water tank.
You added too much liquid
cleaner to the water.
The roller brush is blocked.
The roller brush is blocked by
fabric or surfaces during
cleaning.
The mini turbo brush is not
fully closed.
The connector between the
mini turbo brush and the
appliance is not placed
properly.
Solution
Remove the wetting strip and clean it.
Make sure that the Velcro strips on the
mopping pad and the Velcro strips on
the water tank are perfectly aligned. Also
make sure the striped side of the
mopping pad is facing outwards, away
from the bottom of the water tank.
Refill the water tank.
Only use an original Philips microfiber
mopping pad. You can buy these
mopping pads in the online Philips shop
at www.shop.philips.com/service or at
your Philips dealer.
Check the cap and make sure it is fully
and properly closed.
Check the strip and make sure that it is
fitted properly n the bottom plate of the
water tank.
Use only a few drops or use a cleaner
that foams less.
Remove hairs from the brush with a pair
of scissors (see user manual).
Keep the mini turbo brush aligned with
the surface and do not push the turbo
brush into soft surfaces.
Make sure that the top and bottom
parts of the mini turbo brush are
properly connected and there is no gap
between the two parts. Check if the
locking ring is in closed position (see
user manual).
Make sure that the connector is pushed
into the mini turbo brush as far as it
goes.
English
11