Troubleshooting Guide - Honeywell TP30WKNR User Manual

TROUBLESHOOTING GUIDE

The following troubleshooting guide addresses the most common problems. If problems persist, call
customer service.
PROBLEM POSSIBLE CAUSE
No electricity.
The power cord is not
Dehumidifier
properly plugged in.
does not start
The water tank is not in
the correct position.
The humidity level setting
is too high.
A door or window is open,
letting in new moisture.
There are other sources
of humidity in the room
(e.g. boiling water in pot).
Unit runs but
the humidity
level does
not decrease
The temperature in the
room is too low.
The dust filter is dirty/
blocked.
Air outlet or intake is
blocked.
SOLUTION
Check for power.
Remove and reconnect the power cord.
Position the water tank correctly into the unit. Unit
will not operate until the water tank is secure in place.
Decrease the humidity level setting.
Make sure all windows or doors to the
outside are closed and tightly sealed.
Switch on the dehumidifier when these
sources are not present.
The dehumidifier is designed to operate between
41°F (5°C) and 89°F (32°C). Moisture removal is
greatly reduced if room temperatures exceed this
temperature range.
Clean the dust filter.
Remove blockage.
EN 22