Table of Contents
Advertisement
INSTALLATION
The stainless steel exterior of the cabinet has been protected by a plastic covering during manufacturing and shipping. This covering can
be readily stripped before installation. After removing this covering, wash the interior and exterior surfaces using a warm, mild soapy water
solution and a sponge or cloth, rinse with clean water and wipe dry.
Shelf
Inside the unit you will find a Shelf and a plastic bag containing Shelf Supports. The Shelf Supports with the "tang" go on the rear Pilasters.
This shelf system allows for easy adjustment to suit your needs.
Door Adjustment
Should the Door ever require straightening, loosen the Screws on the Hinges, square the Door with the cabinet and retighten the Screws.
Door Swing
To reverse the door swing, unscrew the top hinge pin and lift the door off. Remove the top and bottom hinge screws and slide the hinges
out. Remove the hinge screws on the opposite side of the cabinet. Using a stiff putty knife, pry out the gray plastic hinge plugs and install
on the oppsite side of the cabinet and re-install the hinge screws. Insert the hinges in the hinge holes flipping the top hinge. Re-install the
door and top hinge pin and adjust the door for proper seal.
Location
When locating your new refrigerator, convenience and accessibility are important considerations, but the following installation guidelines
must be followed;
•
Always avoid placing the refrigerator adjacent to an oven, heating element or hot air source that would affect the operation of the
unit.
•
For proper ventilation the unit requires the following minimum clearances:
o
3 inches on the sides, back and above the cabinet. Install the rear air baffle per the instructions included.
•
The unit must be level or tilted backwards slightly.
•
When placing the unit on a counter or shelf the structure must be able to support a minimum of 200 pounds.
•
The unit is designed to be sealed to the supporting structure surface with a waterproof sealant as required by NSF International.
To do so, locate the unit in its desired location (following the instructions), apply a bead of sealant around the perimeter and smooth
out with a finger to form a radius with the surface and the unit.
Energy Rating
Your Silver King refrigerator has a class 4 energy rating. The refrigerator was tested at an ambient temperature of 40°C at 40% relative
humidity.
4
Advertisement
Table of Contents
