Related Manuals for Silver King SKRS28-ESUS10
Summary of Contents for Silver King SKRS28-ESUS10
- Page 1 Technical Manual Replacement Parts List Shelf Refrigerator MODELS: SKRS28-ESUS10 SKRS28-ESUS11 1600 Xenium Lane North, Minneapolis, MN 55441-3787 Phone (763) 923-2441 FORM NO. 46469-SK REV B 08/2021 Specifications Subject to Change Without Notice.
- Page 2 INSPECT FOR DAMAGE AND UNCRATE Upon delivery of your new Silver King unit, uncrate at once to inspect for possible damage following the instructions printed on the exterior of the container. Report any damages to the carrier responsible for transportation and promptly present a claim for any evidence of mishandling.
-
Page 3: Installation
Energy Rating Your Silver King refrigerator has a class 4 energy rating. The refrigerator was tested at an ambient temperature of 40°C at 40% relative humidity. -
Page 4: Operation
Defrost Your Silver King refrigerator is an automatic defrost unit and no additional plumbing is required. Automatic defrosting is accomplished when frost buildup on the evaporator coil is cleared during compressor “off” cycles. Defrost water is collected in a pan located in the compressor compartment where it is evaporated into the room air. - Page 6 LIST REPLACEMENT PARTS - SKRS28-ES ITEM NO. PART DESCRIPTION PART NO. PILASTER SHELF 42984 SHELF SUPPORT 99530 SHELF SUPPORT W/ TANG 99531 SHELF 42552 DOOR ASSEMBLY COMPLETE 38997 DOOR GASKET KIT 10310-81 HINGE TOP 27181 PIN HINGE 22415 HINGE BOTTOM 38988 DOOR BUSHING 99711...
- Page 8 Thermistor Field Testing Use the guide below to test if a thermistor (temperature probe) is functioning properly. See the replacement parts list for part number information. Table 2 is valid for all thermistors listed on table 1. Establish Thermistor Temperature ...
- Page 9 Silver King’s review to be inefficient or inoperative due to defects in material or factory workmanship.
- Page 10 Equipment, that it will replace the compressor with one of similar design and capacity, exclusive of delivery and installation charges, if it is found subject to Silver King’s review to be inefficient or inoperative due to defects in material or factory workmanship. It is the original purchaser’s responsibility to return the serial plate of the defective compressor, or at Silver King’s option the complete compressor, to the factory.
- Page 11 (Returned Merchandise Authorization) form must be completed and then approved by Silver King. Please contact Silver King for details. Restocking fee will apply. • All electrical equipment is single phase. • Prices, designs, and specifications are subject to change without notice. • Payments via credit card are subject to a 3.5% surcharge.