Related Manuals for Silver King SKR27A-ED 115V
Summary of Contents for Silver King SKR27A-ED 115V
- Page 1 Technical Manual & Replacement Parts List Refrigerator MODEL: SKR27A-ED 115V 1600 Xenium Lane North, Minneapolis, MN 55441-3787 Phone (763) 923-2441 FORM NO. 45287-SK REV F 08/2021 Specifications Subject to Change Without Notice.
- Page 2 INSPECT FOR DAMAGE AND UNCRATE Upon delivery of your new Silver King unit, uncrate at once to inspect for possible freight damage following the instructions printed on the exterior of the container. Report any damages to the carrier responsible for transportation and promptly present a claim for any evidence of mishandling.
-
Page 3: Installation
Your Silver King refrigerator is equipped with an eight (8) foot power cord. Any attempt to modify the plug will void the warranty, terminate the manufacturers responsibility, and could result in serious injury. - Page 4 Defrost Your Silver King refrigerator naturally defrosts and no additional plumbing is required. Defrosting is accomplished when frost buildup on the Evaporator Coil is cleared during Compressor “off” cycles. Defrost water is collected in a pan located in the compressor compartment where it is evaporated into the room air.
- Page 7 REPLACEMENT PARTS LIST – SKR27A-ED 115V ITEM NO. PART DESCRIPTION PART NO. DRAWER ASSEMBLY COMPLETE 39959 DRAWER GASKET KIT 10310-76 KIT SLIDES 15.75" (FOR ONE DRAWER) 10451-04 TEMPERATURE INDICATOR 22409 POWER CORD 115V 32199 TEMPERATURE PROBE 38822 CAPILLARY TUBE EVAPORATOR...
- Page 9 Thermistor Field Testing Use the guide below to test if a thermistor (temperature probe) is functioning properly. See the replacement parts list for part number information. Table 2 is valid for all thermistors listed on table 1. • Establish Thermistor Temperature Table 2 ▪...
- Page 10 Silver King’s review to be inefficient or inoperative due to defects in material or factory workmanship.
- Page 11 Equipment, that it will replace the compressor with one of similar design and capacity, exclusive of delivery and installation charges, if it is found subject to Silver King’s review to be inefficient or inoperative due to defects in material or factory workmanship. It is the original purchaser’s responsibility to return the serial plate of the defective compressor, or at Silver King’s option the complete compressor, to the factory.
- Page 12 (Returned Merchandise Authorization) form must be completed and then approved by Silver King. Please contact Silver King for details. Restocking fee will apply. • All electrical equipment is single phase. • Prices, designs, and specifications are subject to change without notice. • Payments via credit card are subject to a 3.5% surcharge.