Table of Contents
Advertisement
INSTALLATION
The stainless steel exterior of the cabinet has been protected by a plastic covering during manufacturing and shipping. This covering can
be readily stripped before installation. After removing this covering, wash the interior and exterior surfaces using a warm, mild soapy
water solution and a sponge or cloth, rinse with clean water and dry.
Casters
The unit comes with plate casters and mounting screws packed inside the unit. To install the casters, first remove the drawers to lighten
the unit, tip the unit on its back, and locate the 4-hole patterns in the base of the unit. Use the hex head screws provided to mount the
plate casters. Align the plate caster over the 4-hole pattern and install the hex screws tightly. Return the unit to the upright position.
**Allow at least two hours of off time before connecting to a power source.
Pans and Pan Supports
The Pans and Pan Supports are packaged with the unit.
Cutting Board
The Cutting Boards are shipped with the cabinet. The Cutting Boards have two holes in them that align with studs installed on the top of
the cabinet. To install the Cutting Boards place the back of the boards under the lip in front of the raised rail and set them down so the
studs on the cabinet top align with the holes in the Cutting Boards. The Cutting Boards are reversible to extend wear.
Drawers
To remove the drawers for cleaning, simply open them fully, lift up on the front of the drawer to remove the front wheels from the drawer
tracks, continue to slide the drawer out until the rear wheels reach the end of the tracks and lift the drawer out of the tracks. To reinstall
the drawer, insert the rear wheels of the drawer into the drawer tracks and slide the drawer back until the front wheels on the drawer can
be inserted into the track, push the drawer into the cabinet. The drawer pans can be removed by lifting them out with the drawer extended.
The drawer tracks can be removed for cleaning when the drawers are removed from the cabinet. With the track fully in the cabinet, simply
lift up on the drawer track to remove it from the cabinet. The drawer slide system is rated for a maximum load of 100 pounds. The
drawers are not designed for or intended to be used as a surface to stand on. At no time should the drawers be extended and used as
a platform for standing on to reach elevated equipment.
Location
When locating your new refrigerator, convenience and accessibility are important considerations, but the following installation guidelines
must be followed:
• Always avoid placing the refrigerator adjacent to an oven, heating element or hot air source that would affect the operation of the unit.
• For proper ventilation, the bottom front and rear of the unit must not be obstructed. The unit must be on legs or casters to raise it off
the floor. The unit can be installed tight on the sides.
• The unit must be level or tilted backwards slightly.
Climate Class Rating
Your Silver King Prep Table has a climate class 4 rating. It is designed for use in areas not exceeding 30°C (86°F).
4
Advertisement
Table of Contents
