Download Print this page

Samsung WF241ANW Troubleshooting Manual page 4

Advertisement

Door Lock Check
Connector CN2, pin 1 (BLUE) and CN2 Pin 3
(BLACK)
Drain Motor Check
Connector RY1, pin 2 (Blu) and CN5 Pin 4 (grey)
Water Valve Check
Connector CN2 Pin 3 (black) to CN5 Pin 2 (Red),
Pin 1 (Blue) or Pin 3 (Pink)
Heater Relay Check
Connector CN2 Pin 3 (Blk) and RY3 (heater relay)
Pin 2 (Red)
EEPROM Clear Mode:
-All option settings are reset to default values.
!! When Main PCB is replaced, EEPROM should be reset !!
How to Enter:
-The unit needs to be on.
-Press Delay Start and Power Keys at the same time.
Error Type
Error Mode
LED
Water Level Sensor
LE
8
Motor Drive Error or
3E
Hall Sensor error
E3
bE
25
Water Supply
nF
3
Error
Fill Hoses Reversed
nF1
System Error
SF1
SF2
SF3
When Door is Locked 120VAC
Unlocked 0VAC
120VAC with the pump On and 0VAC
with the pump off
120VAC with the Valve On and 0VAC
with the Valve off
120VAC with the Heater On and 0VAC
with the Heater off
Details
LCD
Check the Hose where the sensor is connected, may be loose,
pinched, damaged or clogged. Also check the sensor it may be
disconnected or defective. The Main PCB may also be defective
Check the motor drive connector, it may be loose. The hall sensor
may be disconnected, loose or damaged . Check for a foreign ob-
ject inside the motor or motor damage. The stator might be loose
or damaged. The drum might be overloaded from too many
clothes or the relay or PCB might be defective.
Check the water valve wiring harness.
Check whether the water supply valve is clogged with foreign ma-
terial and whether water is supplied properly.
Check for reversed fill hoses
Check water temperature, if sensed as higher than 50 ˚C in the
Wool or Lingerie cycle it will create error.
Check the relays, if they operate correctly replace the Main PCB.
Correct Hot/Cold hose connections
Replace PCB
Test 1
With Power Off, the resistance be-
tween these pins will be 0Ω when
locked
Test 1
Power Off, the resistance should be
13.9Ω
Test 1
Power Off, valve resistance is from
1202Ω - 1245Ω
Test 1
Power Off, heater resistance is
16.6 Ω
Test 2
Test 2
Test 2
Test 2

Advertisement

loading