Cutting Blades; Cleaning - Husqvarna 967953903-00 Operator's Manual

Table of Contents

Advertisement

Available languages

Available languages

MAINTENANCE

Cutting Blades

For the best mowing results, it is important that
blades are correctly sharpened and not damaged.
Replace blades that have been bent or cracked
when hitting obstacles.
Let the service workshop decide if a blade with
large nicks can be repaired/ground or must be
replaced. Balance the blades after sharpening.
Check the blade mounts.
CAUTION! Blades are sharp.
Protect your hands with gloves
and/or wind heavy cloth around
the blades before handling.
The sharpening of blades must be carried out
by an authorized service workshop.
Blade replacement
1. Remove blade bolt by turning counter
clockwise.
2. Install new or resharpened blade with
stamped GRASS SIDE facing towards
ground/grass (down) or THIS SIDE UP facing
deck and cutter housing.
3. Seat the blade's opening firmly onto the cutter
housing.
4. Tighten blade bolt securely.
5. Torque blade bolt to 45-60 ft/lbs (60-81 Nm).
IMPORTANT INFORMATION Special blade
bolt is heat treated. Replace with a Husqvarna
bolt if required. Do not use lower grade
hardware than specified.

Cleaning

Regular cleaning, especially under the mower
deck, will increase the machine's life-span. Clean
the machine directly after use (after it is cooled),
before the debris sticks.
Do not spray water on the top of the mower deck.
Use compressed air to clean the top side of the
mower deck. Do not use a high pressure washer
or steam cleaner. Avoid spraying engine and
electrical components with water.
Clean the underside of the deck with normal
water pressure. Attach the quick connect (from
the accessory packet) to any garden hose. After
mowing, snap the hose to the cleanout port and
turn on water supply.
Restart the mower and engage the blades to use
the spinning action to wash away debris. Make
sure the hose is away from the mower blades.
Do not rinse hot surfaces with cold water. Let unit
cool before washing.
Hardware
Check daily. Inspect the entire machine for loose
or missing hardware.
CAUTION! Use protective glasses
when cleaning and washing.
27

Advertisement

Table of Contents
loading

This manual is also suitable for:

Z 248f

Table of Contents