Advertisement
4. Set the IR Receiver Kit
WARNING
!
Buttons and the dip switch of the IR Receiver Kit
(1) The location of IR Receiver Kit and its
dip switch is shown in the figure below.
COOL Button
RUN
DEFROST
Dip Switch DSW1
Factory-setting
Dip Switch DSW2
Factory-setting
(2) Buttons "
" and "
using the wireless remote controller.
Button "
": Press "
Button "
": Press "
NOTE:
During emergency operation, the yellow indicating light on the IR Receiver Kit is flashing
in the cycle of 0.5 second on/0.5 second off.
Before setting the dip switch of the IR Receiver Kit, make sure it is
powered off, otherwise, it may cause electric shock.
NOTE:
After the dip switch is set, keep an eye on the location to
draw out the wire when installing the box cover.
COOL
HEAT
Back of the IR Receiver Kit
" are for emergency operation. It is used for operating the unit directly without
" to start cooling operation; Press "
" to start heating operation. Press "
SIGNAL
HEAT Button
IR Receiver Kit Indicator Lamp
TIMER
FILTER
Circuit
board
Cover
" again to stop.
" again to stop.
-5-
Screw o cover
Advertisement
