Advertisement
•
How to remove the IR Receiver Kit
a. Insert a coin or a flat screwdriver in the coil hole on Ⓐ in the corner box's protective cover, screw
it downward and the corner box's protective cover upsprings. In this case, insert the coin or a flat
screwdriver in the coin holes on Ⓑ and Ⓒ, screw it downward, the protective cover up springs
like Ⓐ. When 3 snap springs pops up, pull them out in the direction Ⓓ.
b. As shown in the figure below, hang the band on the rear side of the IR Receiver Kit at the hook of
the panel.
NOTE:
Make sure the binding band is hung on the hook.
Otherwise, the IR Receiver Kit possibly falls off
and hurts people when to be taken out.
c. While pushing the wiring into the corner pocket, insert the fixing hooks (2 portions) at Ⓐ to the
square hole of the air panel, and push the IR Receiver Kit toward the arrow direction (Ⓐ). Then,
insert the fixing hook (1 portion) at Ⓑ to the square hole of the air panel.
NOTE:
Catch securely the fixing hooks of the IR Receiver
Kit to the air panel.
If not, the fixing hooks will be damaged.
(8) After the IR Receiver Kit is installed, begin installing the protective cover of the corner pocket of the
panel (3 places). For installation method, see the panel's Instructions for Installation.
NOTE:
When the IR Receiver Kit is installed, a corner pocket will leave unused.
Blinding
Band
Fixing Hook
Fixing Hook
A
-4-
Hook
A
B
A
B
Advertisement
