MENU + ESC → :
: sets the weight type to display:
- : gross weight;
- : net weight (preceded by letter in 7 segments display).
MENU + ESC → :
The outputs are set as follows by default: /
Possible operation modes:
- (normally open): the relay is de-energised and the contact is open when the weight is
lower than the programmed setpoint value; it closes when the weight is higher than or equal to
the programmed setpoint value.
- (normally closed): the relay is energised and the contact is closed when the weight is
lower than the programmed setpoint value; it opens when the weight is higher than or equal to
the programmed setpoint value.
- : the contact will switch on the basis of gross weight.
- : the contact will switch on the basis of net weight (If the net function is not active, the
contact will switch on the basis of gross weight).
MENU + ESC → :
- Outpu Test:
: setting ensure that the corresponding output opens. Setting ensure that the
corresponding output closes.
- E/EC Option Test:
: it shows the group number of setpoint selected by the E/EC option, if the option is not
present or is not active, the message is displayed
MENU + ESC → :
Pressing ENTER several times scrolls through days - months – years and hours – minutes.
SELECTION OF THE WEIGHT TYPE TO DISPLAY
OUTPUTS AND INPUTS CONFIGURATION
DATE AND TIME SETTING
TEST
- 14 -