Programming Of System Parameters; Serial Communication Settings; Setting The Number Of Decimals; Setting Unit Of Measure - LAUMAS W100RIP Manual

From the weight display, press MENU and ESC simultaneously to access the parameter setting.
MENU + ESC → :
-  / : selects the communication port to configure.
- : disables any type of communication (default);
- : enables weight receiving on selected port;
- : transmission rate (2400, 4800, 9600, 19200, 38400, 115200; default: 9600);
- :
- : no parity (default);
- : even parity;
- : odd parity;
- : stop bit (1 – 2; default: 1).
MENU + ESC → :
 (from 0 to 4): sets the number of decimals; it MUST be equal to the number of decimals
used by the transmitting instrument.
MENU + ESC → :
 (default: ): sets the unit of measure to be used.
- : kilograms;
grams;
- :
tons.
- :

PROGRAMMING OF SYSTEM PARAMETERS

SERIAL COMMUNICATION SETTINGS

SETTING THE NUMBER OF DECIMALS

SETTING UNIT OF MEASURE

- 13 -