Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for NONLINEAR LABS C15
Summary of Contents for NONLINEAR LABS C15
- Page 1 Quickstart Manual...
-
Page 2: Package Contents
Printed C15 Quickstart Manual Unit Connector Cable Do not place the C15 on a soft surface (pillow, mattress, etc.) as this can block the circula- tion of air to the device while it is being used. The C15 is an electrical (and electronic) device: do not allow water to come into contact ... -
Page 4: Setting Up The C15
Setting up the C15 Now the C15 is ready to use and can be switched on. In order to disassemble the paired configuration, undo above four steps in reverse order. The C15’s Base Unit can also be used without the Panel Unit. -
Page 5: Start And Shutdown
A flickering LED indicates an irregular operation mode. It means for example the supply voltage is too low. Make sure not to disconnect the power supply while you are using the C15 (booting up, performance, shutdown), otherwise its data may be lost. -
Page 6: Setting Up A Device For The Graphical User Interface
(NL-C15-) and the name you just gave to the instrument. SSID option to back up preset banks to the external device. The C15 Reference is also accessi- A Wi-Fi network with the same name as the SSID will be displayed ble in the Graphical User Interface. -
Page 7: Introduction To The User Interface
Introduction to the User Interface Storing a Preset Edit Panel FEEDBACK MIXER FLANGER FEEDBACK MIXER FLANGER PM B PM FB Setup Preset Comb S.V.F. E ects Reverb Drive Level Rate Time Mod AP Mod Feedbk COMB FILTER CABINET GAP FILTER PM B PM FB Setup... - Page 8 Center STATE VARIABLE FILTER ECHO REVERB Macro Controls can follow movements of multiple Hardware Sources. There are ten Hardware Sources provided by the C15: four connectors for external pedals, two Ribbons Edit A – B Comb Mix Cut O Reson...
- Page 9 Base Unit Functionality With -/+ you can shift the keyboard range up and down by octaves. Holding one The Base Unit provides four operational modes which can be selected with Mode button while pressing the second will shift the pitch by semitones. ...
- Page 10 If a “FAILED” message appears in the display, the update was not successful. In 5. Switch off the C15 and plug the memory stick into the USB connector at the backside this case please repeat the installation. Rename the installer file to the original of the C15.
- Page 13 NONLINEAR LABS GmbH Helmholtzstraße 2-9 E 10587 Berlin Germany www.nonlinear-labs.de info@nonlinear-labs.de Quickstart Manual Document Version: 4.4 Date: May 24, 2023 © NONLINEAR LABS GmbH, 2023, All rights reserved.