Projecta HDBM35 Manual page 12

Maximum equalization stage voltages for each battery chemistry:
AGM BATT
WET/Flooded Battery
Flooded BATT
Equalization current control
x2 for 24V mode (HDBM35 only)
Remarks: the interface will display 80~99% charged during the Absorption and
Equalization stage.
Float:
Compatible only with Lead-Acid batteries this stage is used for long term battery maintenance.
Float Voltage: 13.6V
Remarks: the interface will display 100% charged during the Float stage. If the voltage
falls below 12.5V, the charger will automatically return to the Bulk mode.
LiFePo Recharge Stage:
4
If the battery voltage falls below 12.8V, the charger will automatically return to the Bulk mode.
If AUTO-DETECT is ON: the charger will automatically restart the charging process from
where it was interrupted in case of a cut in AC power.
5. DIAGNOSTIC MODE (POWER SUPPLY MODE)
The charger will act as a stable, configurable power supply during vehicle
diagnostics, repair and module programming.
Output voltage control:
Output Current Control: 5~150Amp adjustable for the HDBM150 units /
1212
14.5V
14.6V
15.5V
15% of Bulk Current
Step 1: Press
Step 2: Press
Battery Voltage; Output voltage, Maximum Output Current.
Step 3: Press
Displayed Values During Diagnostics:
Load percentage: displays the load on the charger (%)
Current: displays the output current (A)
Voltage: displays the output voltage (V)
Watt: displays the output power (W)
Time: displays the duration
12~15v (x2 for 24V mode) adjustable
1~35Amp adjustable for the HDBM35 units.
to Enter or Exit this Mode.
to Select the desired parameters:
to Start or Stop the mode.