Table of Contents
Advertisement
USING YOUR ICE MAKER
1.
Ensure the drainage plug at the bottom of the water tank is
closed securely.
2.
Plug the ice maker into a wall outlet, the POWER indicator will
blink.
NOTE: The appliance should be rested for 30 minutes before
plugging into a wall outlet, if it has been moved.
3.
Open the transparent lid, remove the ice basket and fill the
water tank with drinkable water.
NOTE: Do not fill above the MAX water level mark.
4.
Replace the ice basket and close the transparent lid.
5.
If you want to clean the appliance, press the SELECT button
and select CLEAN during the standby mode, then press the
ON/OFF button to start cleaning.
6.
The ice making cycle will last approximately 7-15 minutes,
depending on the ambient temperature and water temperature.
7.
The ice making cycle begins with water being pumped into
the ice tray situated below the evaporator. Over the next 7-15
minutes ice forms on the evaporator. Once this has completed,
the ice tray will tilt backwards and the remaining water in the
ice tray is drained back into the water tank. Ice cubes are then
dropped from the evaporator and pushed forward into the ice
basket by the ice shovel. The ice tray will automatically move
back into position under the evaporator and start the next
cycle.
8.
The ICE FULL indicator will illuminate when the ice basket is
full and the ice maker will stop making ice automatically. Gently
remove the ice from the ice basket with the ice scoop. About 5
seconds later, the ice maker will restart its ice making function
automatically.
9
Advertisement
Table of Contents
