Maintenance And Cleaning - BorMann PRO BPH3100 Manual

EN
Switching ON and OFF
Switching on: Press the ON - OFF switch (8).
Switching off: Release the ON - OFF switch (8).
Overload Clutch
If the drill bit becomes jammed or caught, the drive to the drill spindle is interrupted.
● Because of the forces that occur as a result, always hold the machine with both hands and take a secure stance. The machine should be used only with an
auxiliary handle.
Auxiliary Handle (6)
You will be able to obtain a safe position when working by rotating the handle attachment. Loosen and turn the handle attachment in an anticlockwise direction.
Then tighten the handle attachment.
Depth Stop (5)
Loosen the winged screw on the auxiliary handle (6). Adjust the drilling depth on the depth stop (5). Retighten the winged screw.
Operating Modes
WARNING! When switching operation modes please trigger ON/OFF switch slightly.
1. Hammer drill mode:
Turn the mode selector switch (7) to mode "
2. Chiselling mode
Turn the mode selector switch (7) to mode "
3. Changing the chiselling position
The chisel can be locked in various positions. In this manner, the optimum working position can be set for each ap-
plication. Insert the chisel into the tool holder.
Adjust to the desired angle of chisel bit, then switch back to chisel mode.
4. Drilling (see Fig.1)
Turn the selector to this position in order to active the drilling mechanism. Hammering action is not engaged when this mode is selected.

Maintenance and Cleaning

WARNING: Before any work on the machine itself, pull the mains plug.
For safe and proper working, always keep the machine and the ventilation slots clean.
Clean the tool mount daily.
Replacing the Dust Protection Cap
Damaged dust protection caps should be replaced as possible since dust that enters the tool holder can cause malfunctions.
Pull back and hold the locking sleeve pull off the dust cap 4 with a suitable tool.
With the locking sleeve pulled back, pull on the new dust cap until it sits firmly over the tool holder and the locking sleeve can again be slid forward.
If the machine should happen to fail despite the care taken in manufacture and testing, repair should be carried out by an authorised customer service agent.
ENVIRONMENTAL DISPOSAL
In order to avoid damages on transportation, the tool has to be delivered in solid packaging. Packaging as well as the unit and accessories are made of
recyclable materials and can be disposed accordingly. The tool's plastics components are marked according to their material, which makes it possible to remove
environmental friendly and differentiated because of available collection facilities.
Only for EU countries
Do not dispose of electric tools together with household waste material!
In observance of European Directive 2002/96/EC on waste electrical and electronic equipment and its implementation in accordance with
national law, electric tools that have reached the end of their life must be collected separately and returned to an environmentally compatible
recycling facility.
5
" (see Fig.1).
" (see Fig.1).
(see Fig.1)
WWW.NIKOLAOUTOOLS.GR
Fig.1