Additional Safety Warnings; Before Use - BorMann PRO BPH3100 Manual

EN

Additional safety warnings

Working safely with this machine possible only when the operating and safety information are read completely and the instructions contained therein are
strictly followed.
Before using for the first time, ask for a practical demonstration.
If the cable is damaged or cut through while working, do not touch the cable but immediately pull the mains plug.
Never use the machine with a damaged cable.
Wear safety glasses, protective gloves and sturdy shoes.
Wear ear protection to prevent damage to your hearing.
The machine must not be damp and must not be operated in a wet environment.
Keep long hair away from the machine.
Do not operate while wearing loose clothing.
● Connect the mains plug only when the tool is switched off. After using, pull the mains plug.
● Always direct the cable to the rear away from the machine.
● Do not carry the machine by the cable.
● When working with the machine, always hold it firmly with both hands and provide for a secure stance.
● During pauses in the work, when not in use or during work on the machine itself (e.g., changing of the working tools, repairs, cleaning, adjustment), pull the
mains plug.
● Persons under 16 year of age are not permitted to operate this machine.
● Keep the tool accessories out of the reach of children.
● Only use original accessories.
Residual risks
Even when the tool is used as prescribed it is not possible to eliminate all residual risk factors. The following hazards may arise in connection with the tool's
construction and design:
1. Damage to lungs if an effective dust mask is not worn.
2. Damage to hearing if effective hearing protection is not worn.
3. Health defects resulting from vibration emission if the power tool is being used over longer period of time or not adequately managed and properly main-
tained.
Wear hearing protection while operating the power tool.
WARNING! This machine produces an electromagnetic field during operation. This field may under some circumstances interfere with active or passive med-
ical implants. To reduce the risk of serious or fatal injury, we recommend persons with medical implants to consult their physician and the medical implant
manufacturer before operating this machine.

Before Use

Be careful of hidden electrical lines or gas and water pipes. Check the working area, e.g. with a metal detector.
Always use the correct supply voltage!
The voltage of the power source must agree with the value given on the nameplate of the machine.
Operating instructions
Tool Changing
Take care that the dust protection cap (3) is not damaged when changing tools.
SDS-PLUS Tools
The SDS-plus tool is designed to be freely movable.
This causes eccentricity when the machine is offload. However, the drill automatically centres itself during operation. This does not affect drilling precision.
Inserting
● Clean and lightly the tool before inserting.
● Insert the dust-free tool into the tool holder (2) with twisting until it latches.
● The tool locks itself. Check the locking by pulling on the tool.
Removing
● Pull the locking sleeve (4) to the rear and hold while removing the tool.
Non SDS-PLUS tools
Do not use tools without SDS-plus for hammer drilling or chiselling!
4
WWW.NIKOLAOUTOOLS.GR