4
Adjust the angle of the Mounting Hook
using the hexagon wrench supplied with
the Wall-Mount Bracket.
When installing the TV parallel to the wall (0
degrees), adjustment of the Mounting Hook
angle (procedures 1 and 2 below) is not
necessary. Make sure that each arm base X is
screwed in securely.
1 Remove the two screws from the arm base X of
the Mounting Hook. Choose the holes
corresponding to the desired angle (5, 10, 15 or
20 degrees).
2 Adjust the angles of the top Y and bottom Z
arm to fit the corresponding hole, and firmly
secure each arm using the two screws removed in
the previous procedure 1.
GB
Hexagon
wrench
Notes
• Be sure to adjust the right and left arms to the same
angle.
• Make sure that the two arm bases are screwed in
securely.
CAUTION
Be careful not to pinch your fingers when adjusting
the angle of the Mounting Hook.
4
(GB)
5
Lift the TV off the stand. Make sure that
you carry out this task with at least two
or three people.
Do not attempt to lift the TV by yourself.
Step 5: Installing the TV on
the wall
Refer to the Instructions for SU-WL500.
Notes
• When you put the TV back on the stand, reverse the above
steps (insert the posts of the stand, aligning with the lines
on the rear of the TV).
• When moving the TV, do not squeeze the bottom of the
front panel too strongly.
• Remove the screws or install the Mounting Hook on a
stable and level surface.