Force Recovery Mode - Avermedia D115ONB Manual

$ gpio_id=483
$ echo $gpio_id >/sys/class/gpio/unexport
For L4T (Linux for Tegra) BSP support and the other software support associated with
NVIDIA® Jetson Nano / TX2 NX/ Xavier NX/Orin NX/Orin Nano , please visit AVerMedia
website to contact our technical support function.
(https://www.avermedia.com/tw/support/contact)

3.0 Force Recovery Mode

USB 3.l/ Jetson platform
be used to re-program NVIDIA® Jetson NANO/TX2 NX/Xavier NX/Orin NX/Orin Nano by
using the other host system running NVIDIA Jetpack, as the procedure described below.
1. Power off the system. Ensure the system power must be completely OFF, instead of staying
in the suspend mode or the sleep mode.
2. Connect a USB cable from
used to re-program the new system file into NVIDIA® Jetson NANO/TX2 NX/Xavier
NX/Orin NX/Orin Nano
3. Press and hold down Force Recovery Button and then power on the carrier board.
4. After three seconds, release Force Recovery Button.
5. NVIDIA® NANO/TX2 NX/Xavier NX/Orin NX/Orin Nano will show up on the USB list of
the host system as a new NVIDIA target device.
After the system software is updated successfully, please ensure to power off the system. A clean
power-on will then revert
NX215/ NO115B/TN115B/NX215B/D115ONB/D115OXB User Manual www.avermedia.com
port of NX215/NO115B/TN115B/NX215B/D115OXB/D115ONB can
Jetson platform
Jetson platform port back to the host mode.
USB port to the other host system which will be
47