Force Recovery Mode - Avermedia NX215 Manual

$ gpio_id=483
$ echo $gpio_id >/sys/class/gpio/unexport
For L4T (Linux for Tegra) BSP support and the other software support associated with
NVIDIA® Jetson Nano / TX2 NX/ Xavier NX , please visit AVerMedia website to contact
our technical support function. (https://www.avermedia.com/tw/support/contact)

5.0 Force Recovery Mode

USB 3.l/ Jetson platform
re-program NVIDIA® Jetson NANO/TX2 NX/Xavier NX/Orin NX by using the other host
system running NVIDIA Jetpack, as the procedure described below.
1. Power off the system. Ensure the system power must be completely OFF, instead of staying
in the suspend mode or the sleep mode.
2. Connect a USB cable from
used to re-program the new system file into NVIDIA® Jetson NANO/TX2 NX/Xavier
NX./Orin NX
3. Press and hold down Force Recovery Button and then power on the carrier board.
4. After three seconds, release Force Recovery Button.
5. NVIDIA® NANO/TX2 NX/Xavier NX/Orin NX will show up on the USB list of the host
system as a new NVIDIA target device.
6. After the system software is updated successfully, please ensure to power off the system. A
clean power-on will then revert
NX215/ NO115B/TN115B/NX215B/D115OXB User Manual www.avermedia.com
port of NX215/NO115B/TN115B/NX215B/D115OXB can be used to
Jetson platform
Jetson platform
USB port to the other host system which will be
port back to the host mode.
47