Traxxas STAMPEDE 4x4 BRUSHLESS Manual page 28

28 • RUSTLER 4X4
MAINTAINING YOUR MODEL
Suspension and slipper clutch assembly removal
Your model was designed with ease of disassembly in mind. The entire front and rear suspension
assemblies can be removed from the chassis fully intact with the removal of only a few screws.
Refer to the exploded views included in the your model's Service Support Guide for complete
assembly diagrams.
• Removing the front suspension module
1. Remove the two 4x12 button-head cap screws from the front of the chassis.
2. Remove the two 4x10 button-head cap screws from the top of the chassis.
3. Remove the 3x15 button-head cap screw from the steering link under the chassis.
4. Pull the front suspension assembly away from the chassis.
5. The driveshaft will come out with the front module. Remove screw pin to remove driveshaft.
• Removing the rear suspension module (Slipper clutch assembly removal)
1. Remove the two 4x12 button-head cap screws from the top of the chassis.
2. Remove the two 4x12 button-head cap screws from the bottom of the chassis.
3. Pull the rear suspension assembly away from the chassis.
4. The slipper clutch assembly can now be removed.
Front Suspension
Assembly
4x10 BCS
4x12 BCS
Slipper Clutch Slipper Clutch
Assembly Assembly
3x15 BCS
4x12 BCS
Rear Suspension
Assembly
4x14 BCS