Install The Battery Pack; Remove The Battery Pack; Operation; Examine The Chain Oil - GreenWorks CS48L4411 Operator's Manual

Hide thumbs Also See for CS48L4411:
Table of Contents

Advertisement

Available languages

Available languages

3. Monitor the oil indicator (7) to make sure that no dirt
gets into the oil tank while you add the oil.
4. Put the oil cap on.
5. Tighten the oil cap.
6. The whole oil tank will last for approximately 20- 40
minutes.
IMPORTANT
Do not use dirty, used or contaminated oil. Damage
can occur to the bar or chain.
8.3

INSTALL THE BATTERY PACK

WARNING
If the battery pack or charger is damaged, replace
the battery pack or the charger.
Stop the machine and wait until the motor stops
before you install or remove the battery pack.
Read and understand the instructions in the
battery and charger manual.
NOTE
Optimize the power and performance of your new
2x24 machine by running with both batteries charged
to 100%.
1. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2. Push the battery pack into the battery compartment
until the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
8.4

REMOVE THE BATTERY PACK

1. Push and hold the battery release button (18).
2. Remove the battery pack from the machine.
9

OPERATION

NOTE
Remove the battery pack and keep hands clear of the
lock out button when you move the machine.
English
Examine the chain tension before each use.
9.1
Do not use the machine without sufficient chain oil.
1. Examine the oil level of the machine from the oil
2. Add oil if necessary.
9.2
18
1. The grip area is within 100 mm behind the lock out
2. Hold the chainsaw with your right hand on the rear
3. Hold the handles with the thumbs and the fingers
4. Make sure that your left hand holds the front handle
9.3
1. Press the lock-out button (4).
2. Press the trigger (5) while you hold the lock-out
3. Release the lock-out button.
The chain brake must be disengaged for the chain
saw to start. Activate the brake by moving the front
hand guard forwards.
9
IMPORTANT

EXAMINE THE CHAIN OIL

NOTE
indicator.

HOLD THE MACHINE

button.
handle and left hand on the front handle.
around them.
and your thumb is below the handle.

START THE MACHINE

button.
IMPORTANT
EN
4
5

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cse405

Table of Contents