Craftsman 340 Series Operator's Manual page 7

4. Tighten the bolt securely after securing the handle brace. See Figure 4.
5. Locate the carriage bolt, bell washer and hand knob packed with your tiller.
6. Insert the carriage bolt through the welded bracket on the handle, bell
washer, handle brace and into the hand knob. See Figure 4.
7. Select one of the three handle height positions (three notches in the welded
handle bracket) and tighten the hand knob to secure the handle in the
desired position. See Figure 4. Return to the lower handle and tighten the
hex bolt securely.
Attaching the Depth Stake
1. Remove the two screws from the depth stake assembly. See Figure 5.
Depth Stake
Assembly
Hand Knob
Carriage Bolt
Bell Washer
Handle Brace
Figure 4
Screws
Figure 5
ASSEMBLY
2. Insert the depth stake assembly into the frame and reinstall the two screws
removed earlier. Tighten the hex bolts securely. See Figure 6.
Depth Stake
Assembly
3. Secure the pin with the clip removed earlier. The depth stake can be placed at
various positions. For setup purposes it is suggested that the depth stake be
assembled with the stake just above or level with the ground surface. For further
instructions on the Depth Stake refer to the Operation Section of this manual.
7
Screws
Figure 6