Initial Installation - Toshiba 23DL934B Owner's Manual

Before switching on the TV, put your decoder and media recorder to Standby if they are connected and
ensure the aerial is connected to your TV. To set up the TV, use the buttons on the remote control as
IMPORTANT: Ensure that the aerial is connected and
a Common Interface module is not inserted before
switching on the TV for the fi rst time installation.
1. Connect the mains plug and switch the TV to on
using the side control switch. If the TV does not
switch on, press any numbered or
the remote control, then the language selection
menu will be displayed. This screen will appear
the fi rst time that the TV is switched on and each
time the TV is reset.
2. By pressing Up or Down button, highlight the
language you want to set and press OK button.
The following message will be displayed next:
3. By pressing Left or Right button, select the
country you want to set and press Down button
to highlight the Search Type option. Use Left or
Right to set the desired search type. Available
search types are digital only, analog TV only
and full.
4. When set, Down buton to select Teletext
Language. Use Left or Right button to select
desired Teletext Language.
5. Press OK button on the remote control to continue
and the following message will be displayed on
the screen:
01_MB62_[GB]_(01-TV)_IDTV_(IB_INTERNET)_woypbpr_(23155LED_1911UK)_NICKEL17_10077816_10077346.indd 19 01_MB62_[GB]_(01-TV)_IDTV_(IB_INTERNET)_woypbpr_(23155LED_1911UK)_NICKEL17_10077816_10077346.indd 19

Initial Installation

detailed on page 13.
button on
6. Select
and press OK button to continue. Afterwards, the
following OSD will be displayed on the screen:
7. If you select
will be displayed:
8. You can select frequency ranges from this
screen. For highlighting lines you see, use Up or
Down button. You can enter the frequency range
manually by using the numeric buttons on the
remote control. Set Start and Stop Frequency as
desired by using numeric buttons on the remote
control. After this operation, you can set Search
Step as 8000 kHz or 1000 kHz. If you select
1000 kHz, the TV will perform search process
in a detailed way. Searching duration will thus
increase accordingly. When fi nished, press OK
button to start automatic search.
9. If you select
screen, the television will search for broadcasts.
10. The Auto tuning screen will appear and the
television will start to search for available stations.
The progress bar will move along the line. You
must allow the television to complete the search.
The following OSD will be displayed on the screen
and the television will search for the selected
broadcasts:
English - 19 -
Yes button by using Left or Right button
Cable option, the following screen
Aerial option from the Search Type
05.05.2012 19:10:43 05.05.2012 19:10:43