Initial Installation - Toshiba 46BL712G DIGITAL Series Owner's Manual

Before switching on the television put your decoder and media recorder to Standby if they are connected
and ensure the aerial or cable is connected to your television. To set up the television use the buttons on
IMPORTANT: Ensure that the aerial or cable is
connected and a Common Interface module is not
inserted before switching on the TV for the fi rst time
installation.
1. Connect the mains plug and switch the T
using the standby switch. If the TV does not switch
on, press any numbered or standby button on the
remote control, then the language selection menu
will be displayed. This screen will appear the fi rst
time that the television is switched on and each
time the television is reset.
2. By pressing the Up or Down buttons highlight the
language you want to set and press OK button.
The following message will be displayed next:
3. By pressing Left or Right button, select the
country you want to set and press Down button
to highlight the Search Type option. Use Left or
Right to set the desired search type. Available
search types are digital only, analog TV only
and full.
4. When set, Down buton to select Teletext
Language. Use Left or Right button to select
desired Teletext Language.
5. Press OK button on the remote control to continue
and the following message will be displayed on
the screen:
A01_MB65_[GB]_(IB_QSG)_DVB-TC_(3910UK_46975LED)_GOLD14_10079756_50224163.indd 13 A01_MB65_[GB]_(IB_QSG)_DVB-TC_(3910UK_46975LED)_GOLD14_10079756_50224163.indd 13

Initial Installation

the remote control as detailed on page 7.
V on
6. Select
press OK to continue. Afterwards, the following
OSD will be displayed on the screen (*):
7. If you select
will be displayed (*) :
8. You can select frequency ranges from this
screen. For highlighting lines you see, use Up or
Down button. You can enter the frequency range
manually by using the numeric buttons on the
remote control. Set Start and Stop Frequency as
desired by using numeric buttons on the remote
control. After this operation, you can set Search
Step as 8000 kHz or 1000 kHz. If you select
1000 kHz, the TV will perform search process
in a detailed way. Searching duration will thus
increase accordingly.
9. If you select
screen, the television will search for broadcasts.
(*) When finished, press OK button to start
automatic search.
English - 13 -
Yes by using Left or Right buttons and
Cable option, the following screen
Aerial option from the Search Type
28.07.2012 10:19:28 28.07.2012 10:19:28