Description Of Red Indications - Whirlpool AWOE 8559 Instructions For Use Manual

30106320GB.fm Page 10 Tuesday, December 1, 2009 10:47 AM

Description of red indications

Red indication
lights up
Appliance has no or insufficient water supply. The "Start (Pause)" light blinks.
Check whether:
• Water tap is fully open and water supply pressure is sufficient.
• Kinks are present in the water inlet hose.
• Mesh filter of water supply hose is blocked (see "Care And Maintenance".
"Water tap closed"
• The water hose is frozen up.
• The safety valve inspection window of your water supply hose is red (provided
After problem has been removed, restart programme by pressing "Start (Pause)".
If the fault occurs again, contact our After-Sales Service (see next chapter).
Waste water is not pumped out. The appliance stops in the corresponding
programme step; unplug it and check whether:
• Kinks are present in the drain hose, or the hose is blocked for another reason.
• Filter or pump is blocked (see chapter "Draining Residual Water/ Cleaning The
"Clean pump"
• The drain hose is frozen up.
After problem has been removed, push the "Reset" button for at least 3 seconds;
afterwards restart the desired programme. If the fault occurs again, contact our
After-Sales-Service (see next chapter).
Black process 45.0° 130.0 LPI
your appliance has a water supply hose as shown on picture "B" - see previous
chapter "Care And Maintenance"); replace the hose by a new one available
through our After-Sales Service or your specialist dealer.
Filter"; make sure the water has cooled before draining the appliance).
GB 10
Description
Causes
Solutions