Table of Contents
Advertisement
GAS CONNECTION
The gas supply system must comply with the local
regulations.
• The section "national regulations" gives the specific local
regulations for the country of use.
• If no information concerning your country is given, please ask
your installer for more details.
• The hob must be connected to the gas supply or gas cylinder
by means of a rigid copper or steel pipe with fittings complying
with the local regulations, or by means of a
continuous-surface flexible stainless steel tube complying with
the local regulations. The maximum permissible length of the
flexible metal tube is 2 metres.
• Before connecting the tube to the elbow (A), fit the gasket (B)
supplied, in compliance with EN 549.
Important: If a flexible stainless steel tube is used, it must be
installed in such a way that it cannot come into contact with any
movable parts such as kitchen unit drawers or doors, passes through
in a place free of hindrances, and its entire length can be inspected.
• After connection to the gas supply, check for leaks with soapy
water.
ELECTRICAL CONNECTION
The electrical connections must comply with the local
regulations.
• The data relevant to voltage and absorbed power is given on
the dataplate.
• Earthing of the appliance is compulsory by law.
• When installing, provide for an omnipolar cutout switch with
contact opening distance of at least 3 mm.
• If the power cable needs replacing, use one having the same
characteristics as the original supplied standard
(type H05V2V2-F T90°C or H05RRF). This operation must be
performed by the After-Sales Service.
• Do not use extension leads.
• The manufacturer declines any liability for possible
damage or injury due to non-compliance with the
above-mentioned rules.
24
L
Earth
(Yellow/Green)
N
Advertisement
Table of Contents
