Table of Contents
Advertisement
INSTALLATION (FLUSH OR SEMI-FLUSH)
Technical information for the installer
Important: Given the weight of the product, two
people are needed during installation.
• This product can be fitted in a 20 to 50 mm thick
worktop.
• If an oven is not provided for under the hob,
insert a separating panel of size at least equal to
the opening in the worktop. This panel must be
positioned not more than 150 mm from the
upper surface of the worktop, and never less
than 50 mm from the bottom of the hob.
• To install an oven under the hob, make sure it is
manufactured by Whirlpool and equipped with a
cooling device. The manufacturer declines
any liability if another brand of oven is
installed.
Before installation, make sure:
• The local gas supply (type and pressure) and hob
settings are compatible (see the dataplate and
injector table).
• The coverings of the cabinet or appliances
adjacent to the hob are heat resistant in
compliance with the local regulations.
• Fumes are discharged through special extractor
hoods or wall and/or window-mounted electric
fans.
• Natural air circulation is ensured through an
adequate opening in the wall of at least 100 cm
useful section, which must be:
- Permanent and in walls to the outside of the
room;
- Made in such a way that it cannot be
obstructed from the inside or outside
(even accidentally);
- Protected by plastic grilles, metal mesh, etc.,
which do not reduce the above-mentioned
useful area;
- Located near the floor and positioned so as not
to interfere with the operation of the fume
exhaust devices.
2
23
Advertisement
Table of Contents
